This article mainly introduces:

Australia hydraulic cylinder,500 tons hydraulic press cylinder manufacturer,500 tons hydraulic press cylinder

(Australia 500 tons hydraulic press cylinder,produced by Hebei Hengyu company）

500 tons hydraulic press cylinder are widely used in Australia，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed 500 tons hydraulic press cylinder for customers from Australia.

Introduction to 500 tons hydraulic press cylinder:

When the long-stroke 500 tons hydraulic press cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in 500 tons hydraulic press cylinder head seal damage, oil leakage, and piston sleep in the 500 tons hydraulic press cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the 500 tons hydraulic press cylinder; The piston and the piston rod are connected with a spherical joint.

Protection of the 500 tons hydraulic press cylinder surface: During the dismantling process, safety protection should be carried out on the 500 tons hydraulic press cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the 500 tons hydraulic press cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the 500 tons hydraulic press cylinder should be cleaned up in time.

Piston 500 tons hydraulic press cylinder is widely used in hydraulic transmission. When the 500 tons hydraulic press cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the 500 tons hydraulic press cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the 500 tons hydraulic press cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

When the hydraulic oil is not pumped into the 500 tons hydraulic press cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the 500 tons hydraulic press cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

Answers to some questions about 500 tons hydraulic press cylinder:

What valve is used to control cylinder expansion?
Mainly use reversing valve, but the details of the control need hydraulic control valve, hydraulic control valve can be divided into direction control valve, pressure control valve, flow control valve. The valve controls the expansion of the cylinder is the direction control valve, that is, the reversing valve. What is the meaning of two-position three-way and three-position four-way of the reversing valve? Usually according to the different working positions that can stay after the spool is moved, it can be divided into: two-position valves, three-position valves and multi-position valves. According to the number of different slide valve channels can be divided into: two-way valve, three-way valve, four-way valve, five-way valve and multi-way valve. The name of the reversing valve is called the multi-position and multi-pass reversing valve according to its working position and the number of channels.

How to calculate the cylinder diameter, rod diameter and pressure of the cylinder, and how to output tonnage?
Hydraulic cylinder output force F=PAX10^3(KN) F is the output force (KN), P working pressure (MPa), A is the piston or plunger area of action.