This article mainly introduces:

Uruguay hydraulic cylinder,tension cylinder manufacturer,tension cylinder

(Uruguay tension cylinder,produced by Hengyu Hydraulic Co., Ltd）

tension cylinder are widely used in Uruguay，because of long service life，smooth movement，high work efficiency.So our company has designed tension cylinder for customers from Uruguay.

Introduction to tension cylinder:

When using the tension cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the tension cylinder block. If the tension cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the tension cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the tension cylinder, so that the working efficiency of the tension cylinder is reduced.

The tension cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the tension cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the tension cylinder wall due to the stiffness and the weight of the parts, causing scars.

The tension cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the tension cylinder, bite. Elimination method: When installing the tension cylinder, ensure that the axis position of the tension cylinder is consistent with the direction of movement; Make the load borne by the tension cylinder as far as possible through the tension cylinder axis, to avoid the phenomenon of eccentricity.

When the long-stroke tension cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in tension cylinder head seal damage, oil leakage, and piston sleep in the tension cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the tension cylinder; The piston and the piston rod are connected with a spherical joint.

Answers to some questions about tension cylinder:

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.