This article mainly introduces:

Slovakia hydraulic cylinder,magnetic ring induction cylinder manufacturer,magnetic ring induction cylinder

(Slovakia magnetic ring induction cylinder,produced by Hengyu Hydraulic Co., Ltd）

magnetic ring induction cylinder are widely used in Slovakia，because of long service life，smooth movement，high work efficiency.So our company has designed magnetic ring induction cylinder for customers from Slovakia.

Introduction to magnetic ring induction cylinder:

When the initial action of the magnetic ring induction cylinder is slow, please check the temperature of the hydraulic system, because in the case of low temperature, the viscosity of the hydraulic oil is large and the fluidity is poor, resulting in slow action of the magnetic ring induction cylinder. The improvement method is to replace the hydraulic oil with good viscosity temperature performance, and the oil temperature at low temperature can be increased by heater or heating by the machine itself, and the normal working oil temperature of the system should be maintained at about 40 ° C.

Classification of magnetic ring induction cylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.

When using the magnetic ring induction cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the magnetic ring induction cylinder block. If the magnetic ring induction cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the magnetic ring induction cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the magnetic ring induction cylinder, so that the working efficiency of the magnetic ring induction cylinder is reduced.

magnetic ring induction cylinder use should try to avoid sealing belt into the magnetic ring induction cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the magnetic ring induction cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the magnetic ring induction cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

Answers to some questions about magnetic ring induction cylinder:

How many kilograms can the 63 cylinder hold?
The force of the cylinder is related to the cylinder diameter and pressure. 63 cylinder diameter (cylinder inner circle diameter), 21MPA pressure, thrust 6 tons.

What is the function of the hinged cylinder of the shield machine?
The articulated cylinder is used for the shield when the radius of curvature is very small during the propulsion process, that is, for turning. For example, a propulsion section with a radius of curvature of R150 can only be turned using an articulated system due to the sensitivity of the shield body (i.e. the length of the shield body divided by its outside diameter). However, in the construction process, the use of articulated systems is not much.