This article mainly introduces:

Croatia hydraulic cylinder,cylinder with sensor manufacturer,cylinder with sensor

(Croatia cylinder with sensor,produced by Hengyu Hydraulic Co., Ltd）

cylinder with sensor are widely used in Croatia，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed cylinder with sensor for customers from Croatia.

Introduction to cylinder with sensor:

cylinder with sensor use should try to avoid sealing belt into the cylinder with sensor. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the cylinder with sensor. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the cylinder with sensor to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

The coordination of the sliding parts of the cylinder with sensor itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

The difference between the plunger cylinder with sensor and the piston cylinder with sensor is that the piston in the cylinder with sensor is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type cylinder with sensor, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

If air enters the hydraulic system, the cylinder with sensor will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

Answers to some questions about cylinder with sensor:

What is a constant velocity cylinder? What is the difference between hydraulic cylinder and constant velocity cylinder?
The constant speed cylinder should be the same as the speed of the piston rod extension and withdrawal cylinder is called the constant speed cylinder. The difference between it and the ordinary hydraulic cylinder is that the ordinary hydraulic cylinder only has a piston rod extended out, and the general extension speed is slow and the recovery speed is fast, because of the relationship between the effective area. Effective area of piston chamber > Effective area of piston rod chamber. The effective area on both sides of the constant speed cylinder is the same, because there are piston rods sticking out at both ends. The application of constant speed cylinder is most common in grinding machines.

What is the cylinder with rod cavity, what is the rodless cavity.
The rod cavity is the end of the piston rod, the rodless cavity is the end without the piston rod.