This article mainly introduces:

Puerto Rico hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Puerto Rico single rack cylinder,produced by Hengyu Group）

single rack cylinder are widely used in Puerto Rico，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed single rack cylinder for customers from Puerto Rico.

Introduction to single rack cylinder:

In recent years, the processing process of the single rack cylinder generally adopts the rolling method, which is a pressure finishing processing, which uses the cold plastic characteristics of the metal at room temperature, and uses the rolling tool to exert a certain pressure on the surface of the workpiece, so that the surface metal of the workpiece produces plastic flow, and fills in the low concave trough of the original residue, and the roughness value of the workpiece surface is reduced. Due to the plastic deformation of the rolled surface metal, the surface tissue is cold hardened and the grain is fine, forming a dense fiber, and forming a residual stress layer, and the hardness and strength are increased, thus improving the wear resistance, corrosion resistance and compatibility of the workpiece surface. Rolling is a plastic machining method without cutting.

The difference between the integral single rack cylinder and the split single rack cylinder: The integral single rack cylinder and the split single rack cylinder in the single rack cylinder are two different single rack cylinders, and they are very different. The whole single rack cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split single rack cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and single rack cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

The single rack cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the single rack cylinder should pay attention to: the operation should be as far away from the single rack cylinder as possible, to avoid falling objects, knocking, rubbing the single rack cylinder coating. When cleaning the single rack cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the single rack cylinder when the oil temperature exceeds 70 ° C.

Regular maintenance of the single rack cylinder includes: regular tightening, single rack cylinder fastening screws and gland screws, single rack cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the single rack cylinder once a year. Clean regularly, the single rack cylinder is cleaned every other year, and the seals are replaced while cleaning.

Answers to some questions about single rack cylinder:

How to judge the leakage in the cylinder?
Common judgment method: In the production site, people make full use of watching, listening, smelling, touching and other sensory ways, by observing that the cylinder can not move or delay the action or feel the oil temperature change, vibration and noise, etc., and then judge whether the cylinder has internal leakage according to experience. Another method commonly used in the field is to extend the cylinder in place to ensure that the cylinder does not have any load and will not retract (to prevent the cylinder from internal leakage accidents), turn off the machine, and then remove the tubing with the rod cavity, and then press the switch that pulls out the cylinder (do not press the wrong switch). If the oil nozzle with the rod cavity drains the cylinder internally, If there's no oil coming out, you have to think about something else going wrong.

Cylinder la-50-70st What does that mean?
Full model should be CX-LA-50-70ST, thin block cylinder, radial mounting, bore 50, stroke 70.