This article mainly introduces:

Paraguay hydraulic cylinder,lift car cylinder manufacturer,lift car cylinder

(Paraguay lift car cylinder,produced by Hengyu Group）

lift car cylinder are widely used in Paraguay，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed lift car cylinder for customers from Paraguay.

Introduction to lift car cylinder:

The lift car cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the lift car cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the lift car cylinder wall due to the stiffness and the weight of the parts, causing scars.

After the lift car cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

The repair method of the lift car cylinder: the repair of the lift car cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

The scar on the sliding surface of the lift car cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the lift car cylinder wall. Therefore, before installation, these scars must be fully repaired.

Answers to some questions about lift car cylinder:

Why manual forklift oil cylinder can not lift up?
Manual hydraulic forklift truck often can not be pressed up, there are several reasons: for manual hydraulic truck: 1) There is no hydraulic oil 2) the purity of the oil is not enough 3) the adjusting bolt is too close or the adjusting screw is too tight, so that the valve is always open, 4) there is an air in the hydraulic cylinder. Method: 1) Refueling 2) Oil change 3) air discharge. For manual hydraulic stacker, also called manual lift car 1) Less than the amount of oil 2) impurities in the hydraulic oil, so that the check valve can not be closed. Method 1) Add enough hydraulic oil 2) Remove the cylinder, screw off the bottom plate, remove the impurities in the bottom plate.

How to calculate hydraulic cylinder flow?
Effective area of the cylinder x stroke = volume usually in liters. Volume/estimated total travel time (converted to minutes) = oil flow rate.