This article mainly introduces:

Belarus hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Belarus vehicle hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

vehicle hydraulic cylinder are widely used in Belarus，because of no need for deceleration device，long service life，smooth movement.So our company has designed vehicle hydraulic cylinder for customers from Belarus.

Introduction to vehicle hydraulic cylinder:

When installing the vehicle hydraulic cylinder, the axial ends of the vehicle hydraulic cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the vehicle hydraulic cylinder, there is axial expansion. If the two ends of the vehicle hydraulic cylinder are fixed, all parts of the vehicle hydraulic cylinder will be deformed. When disassembling the vehicle hydraulic cylinder, it is strictly forbidden to hammer the vehicle hydraulic cylinder and the piston surface, such as the vehicle hydraulic cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

If it is found that the vehicle hydraulic cylinder lubrication is poor or the vehicle hydraulic cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the vehicle hydraulic cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the vehicle hydraulic cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the vehicle hydraulic cylinder center line. In this way, when the piston works in the vehicle hydraulic cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the vehicle hydraulic cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

vehicle hydraulic cylinders in series, parallel and series parallel. Series: In the vehicle hydraulic cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the vehicle hydraulic cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the vehicle hydraulic cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the vehicle hydraulic cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

The vehicle hydraulic cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the vehicle hydraulic cylinder should pay attention to: the operation should be as far away from the vehicle hydraulic cylinder as possible, to avoid falling objects, knocking, rubbing the vehicle hydraulic cylinder coating. When cleaning the vehicle hydraulic cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the vehicle hydraulic cylinder when the oil temperature exceeds 70 ° C.

Answers to some questions about vehicle hydraulic cylinder:

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.

How to calculate the cylinder diameter, rod diameter and pressure of the cylinder, and how to output tonnage?
Hydraulic cylinder output force F=PAX10^3(KN) F is the output force (KN), P working pressure (MPa), A is the piston or plunger area of action.