This article mainly introduces:

Japan hydraulic cylinder,plating press hydraulic cylinder manufacturer,plating press hydraulic cylinder

(Japan plating press hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

plating press hydraulic cylinder are widely used in Japan，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed plating press hydraulic cylinder for customers from Japan.

Introduction to plating press hydraulic cylinder:

The wear of the hard chromium plating layer of the plating press hydraulic cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

When the plating press hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the plating press hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The plating press hydraulic cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

plating press hydraulic cylinder and hydraulic station selection: Select the type and structure of the plating press hydraulic cylinder according to the operation requirements of the main engine. According to the external load force borne by the plating press hydraulic cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the plating press hydraulic cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the plating press hydraulic cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the plating press hydraulic cylinder, the diameter of the piston and the piston rod.

Answers to some questions about plating press hydraulic cylinder:

What is the difference between hollow and solid oil cylinders?
Hollow solid cylinder, according to conventional understanding, refers to whether the piston rod is solid or hollow. General ordinary hydraulic cylinder, the piston rod is solid structure. Hollow hydraulic cylinder refers to a hollow piston rod structure of the hydraulic cylinder, see the attached figure. Piston rod hollow function: 1, the piston rod hollow, the middle can be threaded rod. For example, the clamping cylinder with a sawing machine, the piston rod center threading rod, part of the stroke through manual, part of the stroke hydraulic automatic walk. 2, the hollow hole of the piston rod can be used to direct the oil circuit to achieve special oil circuit. 3, the cylinder is relatively large, the piston rod is relatively large, and the stroke is longer, in this case, the piston rod is hollow to reduce the movement friction and lateral force.

How to determine the rated working pressure of the hydraulic cylinder?
Under normal circumstances, the working pressure is determined according to the size of the load and the installation space (the allowable diameter of the cylinder). In some special occasions, the smaller the cylinder, the better, the pressure level must be increased. The cylinder pressure is related to the estimated cost. The higher the pressure, the thicker the wall, the higher the cost, but conversely, the lower the pressure, the larger the diameter of the cylinder (when the same thrust) is required, the same high cost. Therefore, the rated pressure of the cylinder is concentrated in about 35 mpa, taking into account the cylinder diameter and wall thickness.