This article mainly introduces:

Slovakia hydraulic cylinder,swager cylinder manufacturer,swager cylinder

(Slovakia swager cylinder,produced by Hengyu Group）

swager cylinder are widely used in Slovakia，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed swager cylinder for customers from Slovakia.

Introduction to swager cylinder:

If the swager cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

The swager cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the swager cylinder, bite. Elimination method: When installing the swager cylinder, ensure that the axis position of the swager cylinder is consistent with the direction of movement; Make the load borne by the swager cylinder as far as possible through the swager cylinder axis, to avoid the phenomenon of eccentricity.

The pressure, temperature, medium and speed of different types of seals are not the same, water-ethylene glycol medium (HFC) can not be sealed with polyurethane, it can only use rubber seal; When the swager cylinder is running fast, it must be sealed with slip ring, such as Sterseal, Glairing, GD1000K, TDI, etc., when the running speed is slow, Yx, U, V combination seals can be used; Fluorine rubber seal is used in high temperature and high pressure environment; When the running speed is fast, the buffer sleeve and buffer valve must be considered.

If the piston rod and swager cylinder are stuck or the swager cylinder is blocked, at this time, no matter how to operate, the swager cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the swager cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

Answers to some questions about swager cylinder:

What adhesive should be used when the cylinder is cracked?
There is a kind of cast iron glue, industrial products market can buy, A, B formula, that is, a tube is A, a tube is B, when used proportionally prepared, check the instructions. Polish the glue after it dries, and then grind it again.

How to calculate the cylinder diameter, rod diameter and pressure of the cylinder, and how to output tonnage?
Hydraulic cylinder output force F=PAX10^3(KN) F is the output force (KN), P working pressure (MPa), A is the piston or plunger area of action.